MX Switch Films (3D Printed)

110 MX Switch Films. These are placed in between the two halves of the housing to reduce tolerances in springs resulting in more cleaner and bassier sound.

Things to keep in mind

- Some Films may have small strings on them (does not affect the quality and can be easily cleaned)

- There may be a slight variation of around ± 0.02mm in the films (does not affect the quality too much)

- If you care about the color of your films, then just let me know the color you want (This may take longer as I may not have that color in stock)

Please be careful with the film as it is a very thin layer of PLA plastic. PLA is a pretty durable plastic and likely won't break however it may bend and crease if it’s handled carelessly. Even if it is bent or creased, it should still work properly. There should be a few extras in your pack just in case this does happen.

Thicc films are designed by Jinra. Read more about them here: https://paper.dropbox.com/doc/Untitled-FZEtIWwgopvJauX0jlG3N

He also goes over Compatability and installation so check it out.

All films are checked by me as they come off the print bed, if you have any defects let me know.